Community > Rohloff Internal Hub Gears
ExBox reassembly problem...
rafiki:
--- Quote from: mickeg on February 07, 2019, 05:39:35 pm ---Is the message here to cut the cables an extra 8 to 10 mm longer than specified to make sure they fit?
--- End quote ---
I don't know. In this case I cut them exactly 200 mm.
mickeg:
--- Quote from: rafiki on February 07, 2019, 07:01:54 pm ---... In this case I cut them exactly 200 mm.
--- End quote ---
Ok. Thanks.
I apparently was confused when it sounded like they did not work at that length in earlier posts.
rafiki:
Ah, OK. I don't know to which length they were cut before as they were the original cables on the bike from new.
rafiki:
Just to update: the Rohloff cables on the Sterling are working fine. No further pulley mishaps so it's my daily ride again. Thanks again everybody.
Navigation
[0] Message Index
[*] Previous page
Go to full version