Thorn Cycles Forum

Community => Rohloff Internal Hub Gears => Topic started by: Mike Ayling on January 02, 2019, 05:20:43 am

Title: Tight EBB on Mercury
Post by: Mike Ayling on January 02, 2019, 05:20:43 am

Last time I loosened the four EBB tightening bolts the EBB slid around easily.

This time it was very difficult to move. I dripped a bit of oil into the keyhole slots under the four bolts but it did not do much good.

How do I lube the EBB case so that it slides around more easily?

Mike

Title: Re: Tight EBB on Mercury
Post by: Dave Whittle Thorn Workshop on January 02, 2019, 10:49:43 am

Hi, Grease on the eccentric works best. The shell of the eccentric is stainless so not very springy, because of this the tabs sometimes need prying apart, you can use a flat screwdriver with the bolts removed, or use the coin method shown here https://www.youtube.com/watch?v=XdFLDSeK7LY

Title: Re: Tight EBB on Mercury
Post by: Mike Ayling on January 02, 2019, 09:22:48 pm

Thanks Dave,

I will give that a go next time.

Mike

Title: Re: Tight EBB on Mercury
Post by: quilkin on September 07, 2021, 11:26:14 am

Be careful with the coin method of prising open the shell. In my case it made matters worse!
See http://thorncyclesforum.co.uk/index.php?topic=14338.0 (http://thorncyclesforum.co.uk/index.php?topic=14338.0) (reply #14) for more deatils.