Author Topic: How does this rear light work ?  (Read 4273 times)

DubblyDubblyDubbly

  • Newbie
  • *
  • Posts: 5
How does this rear light work ?
« on: May 14, 2009, 02:34:11 pm »
My newly acquired 1998 Audax has a Spanninga rear light mounted on the Chromo Plastics mudguards. There's no cables coming from it and on removing the single screw I found no bulb and no batteries. There is no switch anywhere. The previous owner had attached a Cateye light to the storage rack above.. not very sucessfully.
It's obvious where the bulb goes, it's not obvious ( to me) where the battery goes or how it is switched on/off. Any ideas ?
Lots of reference numbers on the red cover... BS6102/3, RR K300 019, BS6102/2, TP RB 3074, CH10345, IA (E4) 013055, (NL) SPANNINGA 15.

« Last Edit: May 14, 2009, 02:53:13 pm by DubblyDubblyDubbly »

rualexander

  • Hero Member
  • *****
  • Posts: 908
Re: How does this rear light work ?
« Reply #1 on: May 14, 2009, 02:48:48 pm »
These are usually designed to work with a cable routed from a dynamo (either hub or bottle type).

freddered

  • Sr. Member
  • ****
  • Posts: 457
Re: How does this rear light work ?
« Reply #2 on: May 14, 2009, 02:52:26 pm »
Unscrew it, open waste-bin, drop into bin, close bin then fit a Cateye TL 610
 

spoon boy

  • Guest
Re: How does this rear light work ?
« Reply #3 on: May 14, 2009, 04:19:20 pm »
It was a dynamo light

if the dynamo is still fitted either re wire it or as suggested take the minga off and fit a proper working hi viz led rear light

assuming of course you ride in the darkness and need a light

john28july

  • Guest
Re: How does this rear light work ?
« Reply #4 on: May 14, 2009, 04:37:07 pm »
Unscrew it, open waste-bin, drop into bin, close bin then fit a Cateye TL 610
Hello,
If you unscrew it and dump it as requested above, please think of me and post it to me. I use hub dynamos on all my bikes and can use this!
John........ ;D

stutho

  • Administrator
  • Hero Member
  • *****
  • Posts: 848
Re: How does this rear light work ?
« Reply #5 on: May 14, 2009, 05:03:30 pm »
As already mentioned it is to wired to a dynamo - The 'Ground' runs through the mudguard (it has an aluminium core) and up the fixing screw.  Much better to rewire this with discrete wires  if you are going to use it!


PS BS6102/3 & BS6102/2 means that it is both a road legal rear light and a road legal reflector.
« Last Edit: May 14, 2009, 08:11:14 pm by stutho »